Extra. Painting-drying booths 

cabina extra
 
The new spray booth Extra for passenger cars is the latest development from Blowtherm aimed at the most demanding spray booth operator. It has been developed to provide exceptional results along with higher productivity. Equipped with the optional Blowpower system, the “Extra” model provides exceptional performance in terms of energy saving, increased productivity, and environmental impact.
 

Extra. The new spray booth with  extraordinary qualities.

The substantial number of installations throughout the world reflects the exceptional success of Blowtherm spray booths.
More than 60 years as the premium brand reflect the quality and reliability of our products.
 

EXTRA. The new spray booth. Blowpower, the innovative extraordinary system.

With the latest European Regulations which enforced the use of water base paints and also the European Directive (EN13355) relating to painting and drying booths, a demand emerged for the introduction of the new Blowpower system in the Extra spray booth. The system optimises the spray booth performance in terms of energy saving, reduction in atmospheric pollution, operational speed and the quality of the finished work. These components can be adapted all together or one by one, according to the specific needs of the customer. The selection of the most advanced technologies optimizes the performance of the spray booth, offers substantial energy savings and provides exceptional results.
 
Led tubes
To increase the lighting inside the spray booth and reduce the energy consumption we install led tubes in our light fixtures.
tubi led
 
Ultra Airspeed

To facilitate the use of the water base products and energy savings, Blowtherm has developed a new system:  ULTRA AIR SPEED, which increases the air velocity up to four times when compared with traditional ventilation systems piping the air in 5 different plenum sections.

The advantages of the system:

  • Shorter flash-off times between coats
  • Energy savings 
  • Shorter curing time
  • Faster removal of volatile components before the start of the reticulation process.
Frequency drive + PLC control Panel

Using frequency drive motors in painting drying booths allows a reduction in the volume of air  in all the phase where a lower volume of air will not compromise paintwork quality, curing performance, or operator safety.

Advantages of the system:

  • Energy saving: lower fuel costs and lower electric power costs
  • Automatic pressure control within the spray booth.
  • Reduced electrical demand peaks and no pressure jumps in the booth box
  • Remote acces device for connection with Ethernet cable and/or 3G SIM Card
  • Hygrometer to check the Humidity degree
  • No.10 Programs for water- based paints, settable by the customer and customizable for special coating applications

det 01 nuovo plc 
Inverter and PLC control panel with latest generation of industrial touch screen.

Direct fired gas burner 

Combustion takes place within the spray booth downdraft air flow.

Advantages of the system

  • 100% efficient
  • Energy saving
  • Shorter operating cycles
  • Fast response to the temperature set 
  • Safety
  • Stable temperature control
  • Burner flue not required
  • Reduced maintenance
 
 det 03

 Heating recuperator

det inv

The highly efficient thermoventilation units, treating high volumes of air, can be equipped with heating recuperators, which recover the heat of the exhaust air (during the spraying and the drying phases) by reintroducing the recovered heat into the intake air supply.

Advantages of the system:

  • Efficiency up to 75%
  • Saving: the heat recuperator offers a considerable energy saving, especially in the winter season
Speed cure 

det 06

Speed Cure is a specific water-based paint program which provides a very quick curing system after which it is possible to work immediately on the vehicle after the cooling phase.

Advantages of the system:

  • Speed: shorter drying cycle
  • Easy to use
  • Economy: as the cycle is shorter, the electrical and fuel consumption per cycle is lower
  • Higher profit from increased productivity
OPTIONAL
  • Integrated pneumatic ramp
  • Semi-downdraft version
  • Generating group above spray booth plenum
  • Special installations with coveyors
  • Electric resistance heater

riscaldatore

Certified and proven quality

certificates-logosBlowtherm invests resources in the pursuit of absolute quality, using more and more newly developed technologies. 
Product quality and customer satisfaction are our main goals, and the approvals obtained from relevant authorities are a testament to our success in these fields. As the premium quality spray booth manufacturer, Blowtherm have been awarded Preferred Supplier Status by many prestigious car manufacturers.